With over 1300 commercial testing labs in the United States, one out of every three samples is for water analysis. There has been an even stronger emphasis on mercury testing and its concentration in our water supplies.
With over 1300 commercial testing labs in the United States, one out of every three samples is for water analysis. There has been an even stronger emphasis on mercury testing and its concentration in our water supplies. This application note describes the use of cold vapor atomic absorption spectroscopy as described in the EPA method 245.1 to determine mercury concentration in water samples including drinking, surface, ground, sea, brackish waters, and industrial and domestic waste waters.
Determine mercury concentrations in surface water samples. In addition to the water samples, pre and post QC checks (15 ppt standards) served to ensure instrument stability and accurate results.
Milestone's Mercurio AAMA-80 incorporates the following sequence to perform a direct measurement in a liquid sample: Aliquot of sample transferred automatically to reaction mixing block through a peristaltic pump where it is mixed with argon gas and a stannous chloride reagent solution, mercury vapors pass through a gas-liquid separator and purification system followed by Hg amalgamation and detection. Following amalgamation, the mercury vapors are released to a single beam, fixed wavelength atomic absorption spectrophotometer. Absorbance is measured at 253.7 nm as a function of mercury content. The system is concurrently cleaned with the amalgamation step for a seamless and more productive process.
Figure 1: Milestone’s Mercurio AAMA-80.
See Table I.
Table I: QC Hg standards and surface water samples
The Mercurio AAMA-80 successfully recovered 100% of the 15 ppt Hg standards and processed 10 surface water samples with excellent reproducibility and accuracy without any interference.
Milestone Inc.
25 Controls Drive, Shelton, CT 06484
tel. (866) 995-5100, fax (203) 925-4241
Website: www.milestonesci.com
Simultaneous Determination of 50 Elements in Geological Samples by ICP-MS Combined with ICP-OES
October 15th 2024A method combining inductively coupled plasma–mass spectrometry (ICP-MS) with inductively coupled plasma–optical emission spectrometry (ICP-OES) was developed for multielement determination of 50 species of major, minor, micro, and trace, rare earth, and rare elements in geological samples.
Identifying Raw Materials Inside Containers with Vaya
October 11th 2024The Agilent Vaya Raman system is a handheld spectrometer capable of identifying raw materials through transparent and opaque containers. This white paper discusses some of the benefits of deploying a Vaya system in a pharmaceutical warehouse, to simplify and accelerate the ID verification of raw materials at receipt.